Euchner CES-AP-CL2-CH (Multicode) Manual de usuario descargar pdf (Pagina 8)

Operating Instructions Safety Switch CES-AP-C.2-CH

Mounting

Caution!

Risk of damage to equipment as a result of incorrect installation. Safety switches 

must not be used as a mechanical end stop. 

 Ì Fit an additional end stop for the movable part of the safety guard.

Important:

 Ì From the assured switch-off distance S

, the safety outputs are safely shut 

down.

 Ì When mounting several safety switches, observe the stipulated minimum 

distance to avoid mutual interference.

min. 400 mm

 Ì The operating distance changes during the mounting of the actuator as a 

function of the material used for the safety guard. Observe arrow direction 

on the device (see ﬁgure below).

Permissible approach directions

Note the following points:

 Ì Actuator and safety switch must be easily accessible for inspection and re-

placement.

 Ì The switching operation must only be triggered by the speciﬁc actuator desig-

nated for this purpose. For permissible combinations please see the table of 

possible combinations on page 4.

 Ì Actuator and safety switch must be ﬁtted so that

 Ì the front faces are at the minimum switch-on distance 0.8 x S

 or closer 

when the safety guard is closed (see section Operating distances). A mini-

mum distance dependent on the actuator must be maintained for a side ap-

proach direction:    - for CES-A-BLN-R2    6 mm 

        - for CES-A-BLN-L2    6 mm 

        - for CES-A-BLN-U2    6 mm 

        - for CES-A-BDN      10 mm

 Ì when the safety guard is open up to the distance S

 (assured switch-off dis-

tance), a hazard is excluded.

 Ì the actuator is positively mounted on the safety guard, e.g. by using the 

safety screws included.

 Ì Pay attention to the maximum tightening torque for the safety switch and 

actuator mountings of 1 Nm.

Installation options

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Sin comentarios

Euchner CES-AP-CL2-CH (Multicode) Manual de usuario Pagina 8