Euchner EKS FSA with Profibus-DP Interface Manual de usuario

Electronic-Key-System Manual Electronic-Key Adapter EKS and EKS FSA with Profibus-DP Interface Order No. 092 009

Manual EKS Electronic-Key Adapter Profibus-DP Each of the outputs is operated with diversity by a dedicated processor that switches off the outputs on

Manual EKS Electronic-Key Adapter Profibus-DP 4 Technical Data 4.1 Dimension drawing of Electronic-Key adapter For installation in a control panel yo

Manual EKS Electronic-Key Adapter Profibus-DP 4.2 Technical data, Electronic-Key adapter Attention! All the electrical connections must either be is

Manual EKS Electronic-Key Adapter Profibus-DP 4.3 Pin assignment 4.3.1 Socket, Profibus-DP PIN Designation Function (according to EIA RS-485) 1 Not

Manual EKS Electronic-Key Adapter Profibus-DP 4.4 DIP switch settings The device address 0...126 (decimal) can be set using the DIP switches S1 to S7

Manual EKS Electronic-Key Adapter Profibus-DP 4.6 Profibus-DP Specification for bus cables A cable specified as cable type A according to EN 50170 mus

Manual EKS Electronic-Key Adapter Profibus-DP 5 Mounting Warning! Mounting must be performed only by authorized personnel. Warning! To achieve the

Manual EKS Electronic-Key Adapter Profibus-DP 6 Electrical connection Electrical connection may only be performed by authorized personnel trained in E

Manual EKS Electronic-Key Adapter Profibus-DP 6.2 Connection of power supply (For information on pin assignment see section 4.3.2 Plug-in screw termi

Manual EKS Electronic-Key Adapter Profibus-DP 6.4.1 Connection example with enabling switch Figure 4: Principle of operation (illustration with select

Manual EKS Electronic-Key Adapter Profibus-DP Table of contents 1 General notes...

Manual EKS Electronic-Key Adapter Profibus-DP The switching contact LA1/LA2, in series with a switching contact on the enabling switch, is connected t

Manual EKS Electronic-Key Adapter Profibus-DP 6.4.1.4 Circuit diagram Figure 5: Circuit diagram with enabling switch 092009-03-10/07 Subject to techn

Manual EKS Electronic-Key Adapter Profibus-DP 6.4.2 Connection example without enabling switch Figure 6: Principle of operation (illustration with sel

Manual EKS Electronic-Key Adapter Profibus-DP The safety relay is de-energized without a time delay (stop category 0) and the machine movement is stop

Manual EKS Electronic-Key Adapter Profibus-DP 6.4.2.4 Circuit diagram Figure 7: Circuit diagram without enabling switch 092009-03-10/07 Subject to te

Manual EKS Electronic-Key Adapter Profibus-DP 7 Setup During setup proceed as follows: Check mounting and electrical connection are correct (see secti

Manual EKS Electronic-Key Adapter Profibus-DP 8 Operation on the Profibus-DP The Profibus-DP is a standardized field bus for decentral peripherals. C

Manual EKS Electronic-Key Adapter Profibus-DP Read-only operation in conjunction with Electronic-Key read-only* (cyclic) Five bytes of Electronic-Key

Manual EKS Electronic-Key Adapter Profibus-DP 8.3 Configuration message After the parameters for the Electronic-Key adapter have been set, the bus mas

Manual EKS Electronic-Key Adapter Profibus-DP 8.6 Read/write operation in conjunction with Electronic-Key read/write 8.6.1 Reading the content of th

Manual EKS Electronic-Key Adapter Profibus-DP 6.3 Connection of function earth...

Manual EKS Electronic-Key Adapter Profibus-DP 8.6.2 Reading/writing any data areas Each time an Electronic-Key is inserted, the Electronic-Key user d

Manual EKS Electronic-Key Adapter Profibus-DP 8.6.3 Reading the serial number The Electronic-Key read/write contains a unique 8-byte serial number. T

Manual EKS Electronic-Key Adapter Profibus-DP 9 Exclusion of liability Exclusion of liability under the following conditions: f if the device is not

Manual EKS Electronic-Key Adapter Profibus-DP 13 Appendix The procedure described below is to be followed when reading or writing arbitrary data areas

Manual EKS Electronic-Key Adapter Profibus-DP Job in progress The job is now executed. The execution of the job is signaled automatically in the input

Manual EKS Electronic-Key Adapter Profibus-DP 13.3 Output area of the bus master Figure 11: Output area of the bus master, example based on SIMATIC

EUCHNER GmbH + Co. KG Telephone +49 711 / 75 97 - 0 Kohlhammerstraße 16 Fax +49 711 / 75 33 16 D-70771 Leinfelden-Echterdingen www.euchn

Manual EKS Electronic-Key Adapter Profibus-DP 1 General notes 1.1 Use of the manual This manual describes the technical features and the function of

Manual EKS Electronic-Key Adapter Profibus-DP 1.1.2 Abbreviations The following abbreviations are used in this manual: f DIP Dual Inline Package f

Manual EKS Electronic-Key Adapter Profibus-DP The following requirements must be met for usage: f The data signal (channel LB) and the switched outp

Manual EKS Electronic-Key Adapter Profibus-DP 2 Safety precautions Warning! The EKS Electronic-Key adapter is not a safety component in the sense of

Manual EKS Electronic-Key Adapter Profibus-DP 3 Function 3.1 Functional description 3.1.1 Common functions of EKS Standard and version EKS FSA The

Manual EKS Electronic-Key Adapter Profibus-DP The connection to the system is made using the integrated Profibus-DP interface. The Electronic-Key adap