Euchner CES-I-AR-M-C04 (Multicode) Manual de usuario descargar pdf (Pagina 14)

Operating Instructions Safety Switch CES-I-AR-M-C04

Connection of a single CES-I-AR

If a single CES-I-AR is used, connect the switch as shown in Figure 3. The OD output

can also be connected here to a control system as a monitoring output.

The switch can be reset via the RST input. To do this, a voltage of 24 V is applied

to the RST input for at least 3 seconds. The RST input must be connected to 0 V

if it is not used.

Important!

The subsystem CES-I-AR complies with PL e in accordance with EN 13849-1. To

integrate the subsystem in a category 3 or 4 structure, it is necessary to monitor

the downstream load (the feedback loop must be monitored).

These examples show only an excerpt that is relevant for connection of the CES

system. The example illustrated here does not show complete system planning.

The user is responsible for safe integration in the overall system.

GND

DC 24 V

CES-I-AR #1

FI1B1

UB2

FO1A3

FO1B4

Plug connector (8-pin)

OD5

FI1A6

0V7

RST8

-K1

-K2

-M1

Figure 3: Connection example for a single CES-I-AR

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 33 34

Sin comentarios

Euchner CES-I-AR-M-C04 (Multicode) Manual de usuario Pagina 14