Euchner CES-AP-C01-CH (Multicode) Manual de usuario descargar pdf (Pagina 8)

Operating Instructions Safety Switch CES-AP-C01-CH

Mounting

Important!

Ì From the assured switch-off distance S

, the safety outputs are safely shut

down.

Ì When mounting several safety switches, observe the stipulated minimum

distance to avoid mutual interference.

min. 80mm

Ì If the actuator is installed ﬂush, the switching distance changes as a function

of the installation depth and the safety guard material.

Operating

distance

Actuator

Operating

distance

Actuator

Flush mounting

Surface mounting

Note the following points:

Ì Actuator and safety switch must be easily accessible for inspection and re-

placement.

Ì The switching operation must only be triggered by the speciﬁc actuator desig-

nated for this purpose. For permissible combinations please see the table of

possible combinations on page 4.

Ì Actuator and safety switch must be ﬁtted so that

Ì the front faces are at the minimum switch-on distance 0.8 x S

or closer

when the safety guard is closed (see section Operating distances). A mini-

mum distance dependent on the actuator must be maintained for a side ap-

proach direction: - for CES-A-BBA 4 mm

- for CES-A-BPA 6 mm

- for CES-A-BRN 12 mm

Ì when the safety guard is open up to the distance S

(assured switch-off dis-

tance), a hazard is excluded.

Ì the actuator is positively mounted on the safety guard, e.g. by using the

safety screws included.

Ì they cannot be removed or tampered with using simple means.

Ì Pay attention to the maximum tightening torque for the read head or safety

switch and actuator mountings of 1 Nm.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Sin comentarios

Euchner CES-AP-C01-CH (Multicode) Manual de usuario Pagina 8